Design of an Automatic Device for Watering Jasmine Flower Plants Using a Soil Based Moisture Sensor Arduino Microcontroller

Nanang

doi:10.31572/inotera.Vol9.Iss1.2024.ID332

Nanang Universitas Pamulang

DOI: https://doi.org/10.31572/inotera.Vol9.Iss1.2024.ID332

Keywords: Automatic Watering, Jasmine Flower, Arduino, Soil Moisture, Pump

Abstract

The In everyday life, watering plants is a very important factor in maintaining and caring for jasmine plants. Water itself is a basic resource that supports the life needs of jasmine plants. If there is no water, the growth of jasmine flowers will be hampered, and the plant can even die. In general, watering plants is done conventionally, this is considered impossible to do in a short time, not to mention when the plant owner is far from where the plants are. In this case, an automatic device for watering jasmine plants was created using a pump controlled by the Arduino Uno, as well as using a soil moisture sensor to provide analog data to the Arduino Uno to regulate the on and off of the water pump based on the humidity that has been set and the use of the LCD module. I2C to display soil moisture, to make it easier for jasmine plant lovers to care for their plants in terms of watering. This research method was adopted from the prototype development method. The results of this research are that the pump can water plants when the humidity is < 30%, and the pump stops watering when the humidity is > 50%.

Downloads

Download data is not yet available.

References

M. Ojha, S. Mohite, S. Kathole, and D. Tarware, “Microcontroller Based Automatic Plant Watering System,” Vol. 5, No. 3, Pp. 25–36, 2016.

K. Punitha, S. Gowda, and R. Devarajnayaka, “Automated Plant Watering System,” vol. 5, no. 18, pp. 1–4, 2017.

K. T. Antara, P. Studi, T. Elektro, F. Teknik, and U. Udayana, “Pengaruh IoT pada Transformasi Jaringan Multimedia : Literatur Review,” vol. 7, 2024.

G. Hergika, P. Studi, S. Komputer, F. Teknologi, I. Universitas, And S. Raya, “Perancangan Internet Of Things ( Iot ) Sebagai Kontrol Infrastuktur Dan Peralatan Toll,” Vol. 8, No. 2, 2021.

M. W. Hidayanto and N. Juliasari, “Rancang Bangun Prototipe Sistem Monitoring Suhu serta Penyemprot Hand Sanitizer Otomatis Berbasis Internet of Things,” vol. 11, pp. 81–85, 2023.

M. N. Fadli, M. W. Alfiansyah, and S. Hadi, “Body Temperature Classification System Based on Fuzzy Logic and The Internet of Things,” vol. 7, no. 2, pp. 35–43, 2024.

Y. Yunidar and M. Melinda, “Position and Temperature Detector for Autism Spectrum Disorder Children based on Sensor and Using IoT System,” vol. 13, no. 6, 2023.

D. A. Chairunnisa, A. Taqwa, and I. Salamah, “The prototype of IOT based weight scale and calorie tracking application,” vol. 7, no. 3, pp. 974–983, 2022.

M. Mina and F. Rahida, “Smart Park LED Strip Based by Internet of Things,” vol. 9, no. 1, pp. 33–38, 2024, doi: 10.31572/inotera.Vol9.Iss1.2024.ID281.

Salya Ratera, Balkhaya,"The Influence of Social Media Digital Marketing Analysis on New Student Acceptance in a University" J.Inotera, vol.8, no.1 pp. 150-154, 2023.

G. D. Derib, “Cooperative Automatic Irrigation System using Arduino,” vol. 6, no. 3, 2017, doi: 10.21275/ART20171731.